Skip to main content

EXP 9 - Perform basic operations using DSP Processor

The next step after designing IIR and FIR filters was to study the DSP Processor. We performed various operations using DSP processor. 
Arithmetic instructions like addition, subtraction and multiplication were performed. Logical instructions like AND and NOT were performed. Also, shift operations like logical shift left , shift right, rotate left and rotate right were performed.

Comments

  1. Unknown25 April 2017 at 22:10

    Have you tried using MPYB instruction?

    ReplyDelete
    Replies
    1. Unknown25 April 2017 at 22:36

      Yes I have used MPYB instruction! It is used for multiplication!

      Delete
  2. Unknown25 April 2017 at 22:22

    You can implement all the previously implemented DSP algorithms on this kit.

    ReplyDelete
  3. Unknown25 April 2017 at 22:27

    Dsp are prefered for signal processing application because of specially designed hardware

    ReplyDelete
  4. Amol25 April 2017 at 22:27

    It has a dedicated bit reversal unit to perform fast algorithms like FFT

    ReplyDelete
  5. Aditi Kajrekar25 April 2017 at 22:33

    Dsp processor acts along with main processor i.e. assists the main processor in applications.

    ReplyDelete
  6. AbhishekGaikwad25 April 2017 at 22:58

    Dsp processors have in built bit reversal unit

    ReplyDelete
  7. Meet Patel25 April 2017 at 23:07

    good

    ReplyDelete
  8. Meet Patel25 April 2017 at 23:08

    GOOD

    ReplyDelete
  9. shrinish_00128 April 2017 at 08:25

    The basic arithmetic operations such as AND,NOT and Shifting operations were understood very well using this approach

    ReplyDelete

Post a Comment

Popular posts from this blog

EXP 6 - Chebyshev Filter design

After designing Butterworth filtwr there was another IIR filter that was to be designed and that was Chebyshev Filter. The filter was designed by coding in SCILAB.  Both Low Pass and High Pass Chebyshev filters were designed and the results were verified by manual calculations. Increasing  the sampling frequency increased the  accuracy of the results obtained.
9 comments
Read more

EXP 5 - Butterworth Filter Design

After learning DFT and FFT techniques it was finally time  to start designing filters. We started with IIr filter  design. The first filter that we were going to design was a Butterworth Filter. Butterworth filter  was designed by using SCILAB. The results were verified by running the program and manually solving  using the same set of values. Results for both Low Pass and High Pass Butterworth filter were verified.
9 comments
Read more

EXP 2 - Discrete Fourier Transform

Discrete Fourier Transform is used to transform signal in time domain to frequemcy domain. In this experiment, we ran a C program to find the DFT of a 4 -ponit and an 8-point sequemce. Also, we plotted their magnitude spectrum. From the magnitude spectrum it was observed that expansion of input signal in time domain gives compressed spectrum in frequency domain.
5 comments
Read more